2 variable length argument lists and arrays
Báo cáo hóa học: " Research Article Joint Source and Channel Decoding for Variable Length Encoded Turbo Codes" ppt
Ngày tải lên :
22/06/2014, 19:20
... mapped to a variable length codeword c(Uk ) The output of the source variable length encoder can be denoted as C(U) = [c(U1 ), c(U2 ), , c(UK )], which is composed of K variable length codewords, ... constraint of K = and N = 10 In the trellis, the state index n denotes the bit length of the sequence after k source symbols have been variablelength encoded (e.g., n3 = 7), and the state transition ... X Jaspar and L Vandendorpe, “Three SISO modules joint source-channel turbo-decoding of variable length coded images,” in Proceedings of the 5th International ITG Conference on Source and Channel...
- 7
- 209
- 0
Friends, Overloaded Operators, and Arrays in Classes
Ngày tải lên :
12/09/2012, 22:53
... > The insertion operator
- 127
- 416
- 0
Pointers and arrays
Ngày tải lên :
30/09/2013, 06:20
... return as its function value? 5.3 Pointers and Arrays In C, there is a strong relationship between pointers and arrays, strong enough that pointers and arrays should be discussed simultaneously ... argc is 3, and argv[0], argv[1], and argv[2] are "echo", "hello,", and "world" respectively The first optional argument is argv[1] and the last is argv[argc-1]; additionally, the standard requires ... (Chapter 3), and strindex and getop (Chapter 4) 5.6 Pointer Arrays; Pointers to Pointers Since pointers are variables themselves, they can be stored in arrays just as other variables can Let us illustrate...
- 27
- 451
- 0
Lab 9.2.6 Troubleshooting Using Ping and Telnet
Ngày tải lên :
19/10/2013, 02:15
... connections on the standard lab setup b Check all physical devices, cables, and connections Step Troubleshoot a Troubleshoot induced network problems b Use the commands ping and telnet to discover ... the lab again with Team members and switching roles Upon completion of the previous steps, log off by typing exit and turn the router off 2-4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9.2.6 ... the routers, enter the global configuration mode and configure the hostname as shown in the chart Then configure the console, virtual terminal, and enable passwords If there are problems doing...
- 4
- 467
- 0
Tài liệu Module 2: Designing a Workstation Installation and Upgrade Strategy ppt
Ngày tải lên :
10/12/2013, 15:15
... CCM technologies and determine their suitability to operating system installation and upgrade Students determine the hardware and software requirements and consider the benefits and shortcomings ... knowledge of unattended and scripted installations Basic experience or knowledge of RIS and SMS The knowledge and skills necessary to define and implement an installation and upgrade plan The lab ... installations and upgrades remotely, the time and effort taken to perform them, and the complexity of the tools and scripts used It is important to identify the number of installations and upgrades...
- 42
- 650
- 2
Tài liệu D02_1585Instructor Notes Module 2: Identifying Business Processes, Challenges, and Vision ppt
Ngày tải lên :
10/12/2013, 16:16
... processes and why? ! Given the type of business and the information available what business processes might be hidden that you can identify? Activity 2.3: Identifying the Business Challenge and Vision ... business challenge and vision statement provided in the Ferguson and Bardell, Inc solution set on the Instructor CD It is important for students to develop their own business challenge and vision statement ... gathering, analyzing, and presenting business requirements that students will use throughout the course It introduces the concept of aligning business and technology groups and using a process...
- 6
- 325
- 0
Tài liệu Configuring Distribute Lists and Passive Interfaces docx
Ngày tải lên :
21/12/2013, 19:15
... been received and replied to Next, ping SanJose3 using extended ping commands (You invoke extended ping by typing ping and pressing Enter in privileged mode.) Using extended commands, source the ... distribute list configured on Singapore, return to SanJose3 and flush the routing table with the clear ip route * command Wait at least seconds, and then use show ip route to check SanJose3’s table: ... complete, you will turn your attention to Auckland Because you are avoiding dynamic routing on Auckland’s WAN link, you decide to use a static route Auckland is a stub network It has only one exit...
- 7
- 403
- 0
Tài liệu Configuring Distribute Lists and Passive Interfaces pptx
Ngày tải lên :
21/12/2013, 19:15
... been received and replied to Next, ping SanJose3 using extended ping commands (You invoke extended ping by typing ping and pressing Enter in privileged mode.) Using extended commands, source the ... distribute list configured on Singapore, return to SanJose3 and flush the routing table with the clear ip route * command Wait at least seconds, and then use show ip route to check SanJose3’s table: ... complete, you will turn your attention to Auckland Because you are avoiding dynamic routing on Auckland’s WAN link, you decide to use a static route Auckland is a stub network It has only one exit...
- 7
- 472
- 2
Tài liệu Lab 4.2.9e Fluke LinkRunner – Cable and NIC Tests ppt
Ngày tải lên :
18/01/2014, 04:20
... is the length of the cable being tested? 2-4 CCNA 1: Networking Basics v 3.0 - Lab 4.2.9e Copyright 2003, Cisco Systems, Inc Step Test length and wire map for good and bad ... was covered in the prior lab Step Test length and continuity for a long cable run The LinkRunner Cable Test function helps to determine whether the cable length is within specification This is ... to determine whether the cable length is within specification, if it is a straight or crossover, and whether it has any faults These tests work for both structured and patch cables This will test...
- 4
- 351
- 0
Tài liệu Lab 4.2.9e Fluke LinkRunner – Cable and NIC Tests docx
Ngày tải lên :
18/01/2014, 04:20
... is the length of the cable being tested? 2-4 CCNA 1: Networking Basics v 3.0 - Lab 4.2.9e Copyright 2003, Cisco Systems, Inc Step Test length and wire map for good and bad ... was covered in the prior lab Step Test length and continuity for a long cable run The LinkRunner Cable Test function helps to determine whether the cable length is within specification This is ... to determine whether the cable length is within specification, if it is a straight or crossover, and whether it has any faults These tests work for both structured and patch cables This will test...
- 4
- 365
- 0
Tài liệu Lab 11.2.2 Configuring Extended Access Lists pdf
Ngày tải lên :
18/01/2014, 05:20
... command mode GAD# copy running-config startup-config Step Confirm connectivity by pinging the default gateway from both hosts a If the pings are not successful, correct the configuration and ... by typing exit Turn the router off 3-5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 11.2.2 Copyright 2003, Cisco Systems, Inc Erasing and reloading the router Enter into the privileged exec ... privileged exec mode enter the command reload Router(config)#reload The responding line prompt will be: System configuration has been modified Save? [yes/no]: Type n and then Enter The responding...
- 5
- 555
- 0
Tài liệu Lab 11.2.3d Multiple Access Lists Functions (Challenge Lab) pdf
Ngày tải lên :
18/01/2014, 05:20
... verified First, verify what lists have been defined From a CLI session on one of the routers with access lists, display the access lists with the Boaz#show ip access -lists command Record the information ... the internal network, design and document the network Complete the preceding charts and include the interface type and number, IP address, subnet 2-8 CCNA 2: Routers and Routing Basics v 3.0 - ... terminal session of one of the routers with access lists, with the Boaz#show ip interface command Look at the output from each interface and record the lists applied to each interface Interface ...
- 8
- 355
- 0
Tài liệu ime Control of a Three Phase 4 Wire PWM Inverter with Variable DC Link Voltage and Battery Storage for PV Application doc
Ngày tải lên :
19/01/2014, 02:20
... in figure To control i rd n o and sepa arately the co oupling elem ments b and d are decoupled b the matrix Fdc and AIdc so that d by xes and de epend only on a and c After removin A ng the coupling ... was discus r ssed in [4], [6 and [8] an 6] nd for three pha inverters in [1], [2], [3], [5] and [7], the dead beat contro in [1] and [2] is adopte ase s d ol ed and extended to mach fo three ... midpoin and a volta and nt age drop occurs which distorts the symm d metrical outp voltage To solve this problem th following put T s he measuremen were take m nts en • • a zer sequence current and...
- 9
- 650
- 0
Tài liệu LESSON 2: BASIC COMMANDS IN LINUX AND WINDOWS docx
Ngày tải lên :
26/01/2014, 20:20
... commands and tools, type in "command /h" or "command /?‚" or "help command" from a MS-DOS window Linux – for additional information on commands and tools, type in "command help" or "man command" ... parallelisms between Windows and Linux For example: the Linux command “command -help” is equivalent to the Windows 13 LESSON – BASIC COMMANDS IN LINUX AND WINDOWS command “command /h” As another example, ... options: netstat/? LESSON – BASIC COMMANDS IN LINUX AND WINDOWS For additional information on these commands and tools type "command /h" or "command /?‚" or "help command" from a MS-DOS window For example,...
- 15
- 502
- 1
(1) how learners approach learning, both in and out of classrooms, and (2) the kinds of strategies and cognitive processing they use in second language acquisition
Ngày tải lên :
29/01/2014, 00:23
... gender and strategy use have come to mixed conclusions Ehrman and Oxford (1989) and Oxford and Nyikos (1989) discovered distinct gender differences in strategy use The study by Green and Oxford ... learning strategies on the learning and teaching of foreign and second language Good choice and use of learning strategies would help learners become more independent and autonomous as well as improve ... humanities used more and a wider range of strategies than those majoring in science/engineering in several studies (e.g., Lee, 1994; Park, 1999) Dreyer and Oxford (1996) and Oxford and Nyikos (1989)...
- 83
- 622
- 0
Tài liệu Báo cáo khoa học: The two Caenorhabditis elegans metallothioneins (CeMT-1 and CeMT-2) discriminate between essential zinc and toxic cadmium docx
Ngày tải lên :
16/02/2014, 15:20
... to CeMT-1 and CeMT-2 if presented with Zn : Cd ratios as encountered by C elegans Using a Cd : Zn ratio of 33 : [21 nm Cd(II) and 0.7 lm Zn(II)] and 0.1 lm of CeMT-1 and CeMT-2 each, and the stability ... metal affinities and their comparison, it was very important to obtain clearly defined homo-metallic species, and the data compiled for Zn6-CeMT-2, Cd6-CeMT-2 and Zn7-CeMT-1 in Fig and Table show ... Table Zinc and cadmium binding affinities for MTs in Caenorhabditis elegans and other species Log K binding constants for zinc and cadmium metalloforms of C elegans MTs were determined and compared...
- 12
- 611
- 0